Roland XPS-60 - Placing this Instrument on a Stand

4
Placing this instrument on a stand
NOTE
Take sucient care not to get your ngers or other body parts pinched when setting up the stand. Place this instrument on the stand as shown
below.
If you want to place the XPS-60 on a stand, use the Roland KS-11Z, KS-13 or KS-20X.
KS-11Z
Align the front of
the XPS-60 with
the front of the
stand.
Adjust the width of the stand so
that the stand arms are lined up
between the rubber feet of the
XPS-60.
Top view
Adjust the stand width
KS-13
Adjust the stand width so that
the rubber feet on the keyboard
side (front) of the XPS-60 t into
the holes provided on the stand.
Top view
Adjust the stand width
KS-20X
Line up the
XPS-60 so
that it rests
on the rubber
rings of the
stand.
Open the stand to its lowest position
(the folded-up position is “1”; the height
adjustment cam should be locked into
the sixth groove).
Align the middle of the XPS-60 with the center of the stand