Roland XPS-60 - Operating the Audio Player

42
Playing back audio les (audio player)
9. Press the pads [1]–[8].
The pads you press blink, and the audio les that are assigned to
each pad play back.
Press the respective pad again to stop playback (the pad lights
up).
Operating the audio player
Action Operation
Play Press the pads [1]–[8].
Stop Press the pad that’s currently playing back.
Adjust the start
or end (*1)
Move the cursor to the Loop Start Point or Loop End
Point, and edit the value with the value dial.
MEMO
While the audio player is playing, move the cursor
to the Loop Start Point/Loop End Point and press
the [SHIFT] + [ENTER] button to input the current
playback point.
Play the audio
To switch to audio immediately:
Press the pads [1]–[8].
To set the audio to play next:
Press the pad you want to play, while holding down
the pad that’s playing back.
Overall volume
for the audio
player
Move the [PHRASE PAD] slider.
(*1) Loop settings are automatically saved for each audio le in the
folder where the audio le is located.
When you move an audio le to another folder, you can also keep
the existing loop settings by moving the audio le together with
the settings le (.bin).