Roland XPS-60 - Rear Panel (Connecting Your Equipment)

8
Panel descriptions
* To prevent malfunction and equipment failure, always turn down the
volume, and turn o all the units before making any connections.
Rear panel (connecting your equipment)
USB ash drive
Power cord
To AC outlet
MIDI device
AC adaptor
Computer
Cord hook
External audio player
Headphones
Speakers
with built-in
ampliers
A B C D E
F G H
I J K
Pedal switch
Expression pedal
L M
Mic
A Ground terminal
Connect this to an external earth or ground if necessary.
B DC IN jack
Connect the included AC adaptor to this jack.
* Use the cord hook to secure the cord of the AC adaptor as shown in
the illustration.
C [POWER] switch
This switches the power on and o (p. 14).
D USB COMPUTER port
Connect this to a computer or mobile device.
* A commercially available USB AC adaptor (5 V
/ 2 A or greater) is
required to supply power to the USB COMPUTER port. Depending
on the manufacturer and type of the USB AC adaptor, correct
operation may not be possible.
* Do not use a USB cable that is designed only for charging a device.
Charge-only cables cannot transmit data.
E USB MEMORY/EXT DEVICE port
Connect a commercially available USB ash drive or external USB
device here.
This is used to play audio les, add World Expansion tones and back
up data (p. 25, p. 41, p. 27, p. 53).
F PEDAL HOLD jack
If you connect a pedal switch (DP series, sold separately) to this
jack, you can use it as a hold pedal. You can also assign various
functions to the pedals that are connected, and control them
(p. 44).
G PEDAL CONTROL jack
If you connect an expression pedal (EV-5, sold separately) or pedal
switch (DP series, sold separately) to this jack, you can use them to
control various functions (p. 44).
* Use only the specied expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage to
the unit.
H MIDI IN, OUT connectors
You can connect a MIDI device to this connector.
I MIC [GAIN] knob
Adjusts the input gain of the MIC INPUT jack (p. 22).
J MIC INPUT jack
Connect a dynamic mic here (p. 22).
* A condenser microphone (phantom powered) cannot be used.
Pin assignment of MIC INPUT jack
1: GND2: HOT
3: COLD
※ 入力端子の場合
1: GND 2: HOT
3: COLD
※ 出力端子の場合
TIP: HOT
RING: COLD
SLEEVE: GND
K EXT INPUT jack
Connect this to your external audio player or similar device.
L OUTPUT R, L/MONO jacks (balanced)
These are balanced output connectors for audio signals.
Connect these to an amplier or mixer. For mono output, connect
to the L/MONO jack.
Pin assignment of OUTPUT R, L/MONO jacks
1: GND2: HOT
3: COLD
※ 入力端子の場合
1: GND 2: HOT
3: COLD
※ 出力端子の場合
TIP: HOT
RING: COLD
SLEEVE: GND
M PHONES jack
Used for connecting headphones (sold separately).