Roland XV-88 - Copying a Patch

183
Chapter 10. Memory Settings (Utility Mode)
Chapter 10
Copying a Patch
To copy the settings of a Patch, press [UTILITY] in Patch
mode, then perform Copy operation.
Patch Tone Copy
Tone settings of a Patch will be copied to the Tone you
specify of the current Patch.
fig.10-13.e
To specify the currently selected Patch as the copy
source, set Source to TEMP.
When the Copy operation is executed, an * symbol will be
displayed in front of the copy-destination Tone.
For more detailed information and instructions for this
procedure, refer to “Copying the Settings of Another
Tone (Tone Copy)” (p. 68).
Patch Effects Copy
You can copy the effect settings from any Performance, Patch
or Rhythm Set into the currently selected Patch.
fig.10-14.e
Press to move to the next display, and then select the
contents of the effect that you wish to copy.
fig.10-15.e
ALL: Multi-effects, Chorus, and Reverb settings
MFX: Multi-effects settings
CHORUS: Chorus settings
REVERB: Reverb settings
CHO&REV: Chorus and Reverb settings
For more detailed information and instructions for this
procedure, refer to “Copying Another Effect Setting
(Effects Copy)” (p. 161).
Patch Name Copy
You can copy the name of a Patch to the current Patch.
fig.10-16.e
Copy source Patch name
Copy destination Tone
Copy source Patch
(group, number)
Copy source Tone
Copy source Performance/
Patch/Rhythm Set
(group, number, name)
Copy source
Copy type
The Compare Function
For the Patch Tone Copy and Patch Effect Copy
operations, you can use the Compare function.
The Compare function allows you to play the copy-
source Patch. To play the Patch of the copy source, press
[UNDO/COMPARE] to access the PATCH COMPARE
page. The new Patch can also be selected from this
page—however, it is not possible to select Patches from
CD-A–H or XP-A–D. After selecting the desired Patch,
return to the previous page by pressing [UNDO/
COMPARE] or [EXIT].
fig.10-06a.e
• The Compare function cannot be used with Patch
Tone Copy if either TEMP, a CD-A–H or XP-A–D
patch is selected as the copy-source Patch.
• The Compare function cannot be used with Patch
Effect Copy if PERFORM is selected as the copy
source.
• The Patch auditioned using the Compare function
may sound slightly different than when it is played
normally.
Copy source Patch (group, number, name)
Copy source Patch (group, number, name)