220
Quick Reference of Procedures
The XV-88 has a large number of functions. This section gives the procedures for using some of the
frequently-used functions. For functions that are used simply by setting the applicable parameter,
only the “Parameter name (mode/display group/display)” is listed.
* “[A] + [B]” indicates “press [B] while holding down [A]”; “[A]
→
[B]” means “press [B] after first
pressing (and releasing) [A].”
Performance Mode
Selecting the Performance
Mode PLAY Page
Press [PERFORM].
Selecting a Performance
Use the VALUE dial, [INC/+], [DEC/-], or numeric keys to
select.
Selecting a Performance
Group
USER: Press [USER].
CD-A–H: Press [CARD] → [A]–[H].
PR-A, B: Press [PRESET] → [A], [B].
Selecting Performances
Using the Digit Hold
Function
1. Press [SHIFT] + numeric key [0] (turn on the Digit Hold
function).
2. Use the numeric keys to specify the number of the one’s
place.
* To turn off the Digit Hold function, press [SHIFT] + [0] once
again.
Changing the Patch/
Rhythm Set Assigned to
a Part
1. Press [PERFORM] + [PATCH].
2. Use / to select a Part.
3. Use the VALUE dial, [INC/+], [DEC/-], or the numeric
keys to select a Patch or Rhythm Set.
Modifying Performance
Settings
(basic procedure)
1. Turn on the [EDIT] indicator.
2. Use the function buttons to select the display group.
3. Use / to select the desired setting page.
4. Turn off the [EDIT] indicator.
5. Use [ZONE/PART SELECT] (function button) to select
the Part.
6. Use / to select a Parameter.
7. Use the VALUE dial, [INC/+], [DEC/-], or the numeric
keys to modify the value.
* If you wish to move to a different display group, turn on the
[EDIT] indicator.
Adjusting the Volume of
Each Part
Level parameter (PERFORM/PART/SETTING)
Adjusting the Pan of
Each Part
Pan parameter (PERFORM/PART/SETTING)
To Next Page
Loading...
