89
Chapter 5. Creating Patches
Chapter 5
TVF VELOCITY
fig.05-69
V-Cutoff (Cutoff Frequency Velocity Sensitivity)
Use this parameter when changing the cutoff frequency to be
applied as a result of changes in playing velocity. If you want
strongly played notes to raise the cutoff frequency, set this
parameter to positive (+) settings. If you want strongly
played notes to lower the cutoff frequency, use negative (-)
settings.
To edit the overall Patch while preserving the relative
differences in the Cutoff Frequency Velocity Sensitivity
values set for each Tone, set the Velocity Sens parameter
(PATCH/COMMON/PATCH MODIFY) (p. 72).
However, this setting is shared by the V-Sens parameter
(PATCH/TVA/TVA) (p. 90).
V-Curve (Cutoff Frequency Velocity Curve)
Selects one of the following seven curves that determine how
keyboard playing dynamics (velocity) influence the cutoff
frequency. Set this to FIXED when the Cutoff frequency is
not to be changed according to the force with which the keys
are pressed.
fig.05-70
V-Resonance (Resonance Velocity Sensitivity)
This allows keyboard velocity to modify the amount of
Resonance. If you want strongly played notes to have a
greater Resonance effect, set this parameter to positive (+)
settings. If you want strongly played notes to have less
Resonance, use negative (-) settings.
TVF ENVELOPE
fig.05-71
fig.05-72
fig.05-73
This is used for setting TVF envelope (how cutoff frequency
changes over time).
Depth (TVF Envelope Depth)
Specifies the depth of the TVF envelope. Higher settings will
cause the TVF envelope to produce greater change. Negative
(-) settings will invert the shape of the envelope.
V-Sens (TVF Envelope Velocity Sensitivity)
Specifies how keyboard playing dynamics will affect the
depth of the TVF envelope. Positive (+) settings will cause
the TVF envelope to have a greater effect for strongly played
notes, and negative (-) settings will cause the effect to be less.
V-Curve (TVF Envelope Velocity Curve)
Selects one of the following 7 curves that will determine how
keyboard playing dynamics will affect the TVF envelope. Set
this to FIXED when the amount of TVF Envelope applied is
not to be changed according to the force with which the keys
are pressed.
fig.05-70
Time KF (TVF Envelope Time Keyfollow)
Use this parameter when you want the keyboard location of
notes to affect times T2–T4 of the TVF envelope. Based on the
TVF envelope times for the C4 key (center C), positive (+)
settings will cause notes higher than C4 to have increasingly
shorter times, and negative (-) settings will cause them to
have increasingly longer times. Higher settings produce
more change.
fig.05-54.e
V-T1 (TVF Envelope Time 1 Velocity Sensitivity)
Use this parameter when you want velocity to affect T1
(Time 1) of the TVF envelope. If you want T1 time to be
speeded up for strongly played notes, set this parameter to a
positive (+) value. If you want it to be slowed down, set this
to a negative (-) value.
1234567
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
To Next Page
Loading...
