Roland XV-88 - Controller Settings

223
Quick Reference of Procedures
Appendices
Controller Settings
Modifying Rhythm Set
Settings
(basic procedure)
1. Turn on the [EDIT] indicator.
2. Use the function buttons to select the display group.
3. Use / to select the desired setting page.
4. Use the keyboard to choose a Rhythm Tone (percussion
sound).
5. Use / to select a Parameter.
6. Use the VALUE dial, [INC/+], [DEC/-], or the numeric
keys to modify the value.
Changing the Rhythm
Set Assigned to a
Performance Part
1. Press [PERFORM] + [PATCH].
2. Use / to select a Part.
3. Use the VALUE dial, [INC/+], [DEC/-], or the numeric
keys to choose the Rhythm Set.
The rest procedure is the same as for the basic procedure listed
above.
Adjusting the Volume of
Rhythm Sets
Level parameter (RHYTHM/COMMON/RHYTHM
COMMON)
Changing the Range of
the Pitch Bend Lever
(for each Patch)
Bend Range parameter (PATCH/CONTROL/TMT
CTRL&BENDER)
Selecting the MIDI
Messages Controlled by
the C1–C4 Sliders
Assign parameters (SYSTEM/CONTROL/C1–C4 ASSIGN)
Selecting the MIDI
Messages Controlled by
the Control Pedal
Assign parameter (SYSTEM/CONTROL/CONTROL PEDAL
1, 2)
Reversing the Polarity of
Control Pedal (when
using a pedal of another
manufacturer whose
polarity is reversed)
Polarity parameter (SYSTEM/CONTROL/CONTROL PEDAL
1, 2)
Selecting the MIDI
Messages Controlled by
the D Beam Controller
In Performance Mode
Assign parameter (ZONE/D BEAM/D BEAM CONTROL)
In Patch/Rhythm Set Mode
Assign parameter (SYSTEM/D BEAM/D BEAM CONTROL)