Installation
Quantum Marina Pedestal MQPM-01-V01-R7 Installation and End User Manual
Page 15 of 23 April 2023
Installation
WARNING: Potable Water
Equipment equipped with potable (drinking) water systems must be
installed in accordance with the appropriate legislation in the region of
installation.
IMPORTANT: Installers and End Users must read and understand the content
of this manual before installation/use.
Installation must only be performed by someone who is properly qualified and
competent to do so in accordance with the appropriate legislation in the region of
installation.
x Rolec Services Ltd cannot accept any responsibility for improper installation or any
problems arising from improper installation.
NOTE: Damage to the equipment, connected systems or to property caused by
improper installation/use are the responsibility of the installer/user.
Before Installation
1. Establish a suitable site location for the unit that is both secure and environmentally
safe.
2. Make sure the location meets current legislation (if applicable).
3. Make sure there is a suitable mains power supply available at the installation site.
4. Make sure there is a suitable water supply available at the installation site (if
required).
x It is important to ensure the water supply is clean and flowing freely.
x Make sure the pipework is thoroughly flushed to remove any debris or stale
water before connecting to the pedestal.
x Clean or replace filters as appropriate
5. Make sure that the unit and any accessories have not been damaged in transit.
NOTE: Items damaged in transit must first be reported to the courier and then to the
supplier.
Where possible, photographic evidence of package and/or unit damage should be
provided.
6. Make sure the unit model is correct and matches the order.
NOTE: Incorrect or damaged units must NOT be installed. Contact your supplier to
discuss rectification.
NOTE: If the pedestal is not going to be sited on a pontoon or similar decking type
location, a firm mounting point will be needed in/on the ground. Refer to the two
sections immediately below on setting up a base location.
To Next Page
Loading...