28
Bleeding the system
• In order to ensure perfect operation of the appliance it is important that the system is bled prior to
initial use or after a longer non-use period.
• If the water tank gets empty during use, the system will suck air which must be removed by bleeding
the system.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Step 2:
Fill the water tank with fresh tap
water.
Observe the “MAX” marking!
Step 3:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 4:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 8:
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water until it comes
without air. Use the water for
warming the cups.
Step 5:
Place a vessel below the outlet of
the hot wa-ter/steam nozzle.
Step 6:
Choose the function
“espresso/hot water”.
Step 7:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 9:
Stop hot water supply.
Turn the rotary knob to the left.
To Next Page
Loading...
