33
Step 14:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
Step 15:
Clean the appliance and the
accessories.
Step 13:
Afterwards remove the portafilter,
empty it and clean it under running
water.
The portafilter drips slightly.
Power save mode:
After 10 min. without operation,
the appliance switches to power
save mode, without heating of the
thermoblock. The pilot lamp blinks
slowly (every 2 sec.).
By tipping the switch for 1 or 2 cups,
the appliance can be activated again.
After a short heating-up phase, the
appli-ance is ready for use.
Programming the cup capacity
• The pre-set capacity for 1 cup is 50 ml and 100 ml for 2 cups.
• The max. programmable capacity for 1 cup is 150 ml and 250 ml for 2 cups.
• The newly programmed capacity is memorised permanently.
Step 3:
Further steps.
Programming the cup capacity for
2 cups is done the same way,
however, with the switch for 2 cups.
Step 2:
Start espresso supply.
Apply the switch for 1 cup and
hold it.
Release the switch as soon as the
desired capacity is reached.
The appliance stops and the new
capacity is programmed.
Follow the steps
1 – 11
“Preparing espresso/coffee”
Step 1:
Prepare the appliance.
Follow the steps
13 – 15
“Preparing espresso/coffee”
Frothing milk
• For having perfect results, we recommend ...
… using refrigerated milk only
… using a stainless steel pot.
• Dip the hot water/steam nozzle in the milk and start frothing in the upper third of the milk. Hold the
pot a little slant and slightly move it up and down. The nozzle must remain under the milk surface as
otherwise the milk froth will be too large-pored. (After a few trials and with a little practice, you will
quickly find the correct method).
To Next Page
Loading...
