32
Step 5:
Remove the portafilter.
Remove residual water from the
portafilter if necessary.
Step 7:
Place the filter insert in the
portafilter and press it on firmly.
Step 8a: (with powder)
Use the enclosed coffee scoop for
filling in powder.
1 coffee scoop (7 g) per cup
Step 8b: (with powder)
Press the powder on with the
enclosed tamper. The rim of the filter
insert must be clean.
Step 8c: (with pad)
Instead of powder, a suitable
espresso pad can be used. It must
not be pressed on. The rim of the
filter insert must remain free.
Step 9:
Position the portafilter with filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 10:
If necessary, the cup tray can be
adjusted in height. For this, push
both buttons simultaneously until
they unlock.
Step 6:
Choose a filter insert:
- small insert for 1 cup
- small insert for 1 pad
- large insert for 2 cups.
Step 11:
Place the cup/cups below the
portafilter.
Step 12a: (1 cup)
Start espresso supply.
Tip the switch for 1 cup shortly.
The appliance stops automatically
afterwards. By tipping the switch
again, the process can be stopped.
Step 12b: (2 cups)
Start espresso supply.
Tip the switch for 2 cups shortly.
The appliance stops automatically
afterwards. By tipping the switch
again, the process can be stopped.
Pre-brew function:
The brewing process is interrupted
after ca. 4 seconds for a few
seconds. The powder is sprinkled
with water and first flavouring
agents are dissolved.
Making espresso:
OR
To Next Page
Loading...
