31
Step 8: (bleeding)
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water until it comes
without air. Use the water for
warming the cups.
Step 9: (bleeding)
Stop hot water supply.
Turn the rotary knob to the left.
Making espresso/coffee
• For a perfect result, we recommend ...
… initial use without lter insert and powder for preheating the system (see step 4a - 4d)
… preheating the cups
… using fresh tap water
… using freshly ground powder
… exchange water in the tank regularly.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 2:
Choose the function
“espresso/hot water”.
Step 3:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 4a: (preheating)
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 4b: (preheating)
Place a vessel below the outlet of
the portafilter.
Step 4c: (preheating)
Start single serving function.
Tip the switch shortly. The appliance
stops automatically afterwards.
Step 4d: (preheating)
Remove the vessel below the outlet
of the portafilter.
• Check the water tank
regularly, refill water if
necessary.
• Check the drip pan
regularly, empty it if
necessary.
Step 1:
Prepare the appliance.
Preheating the system:
To Next Page
Loading...
