EasyManua.ls Logo

Rommelsbacher EKS 2000 - Troubleshooting Flow and Drips; Resolving Espresso Flow Problems

Rommelsbacher EKS 2000
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
espresso flows irregularly or not at
all out of the portafilter
For finding the fault, remove all components (also portafilter) and check
the supply. Assemble the components step by step and check the supply
until you find the cause of defect.
blocked filter insert
Clean the filter insert thoroughly, clean sieve and holes carefully with the
cleaning pin if necessary!
blocked portafilter
Clean the portafilter thoroughly, clean the holes carefully with the cleaning pin
if necessary!
blocked water filter
Remove water filter from the tank and start dispensing water without filter. If the
supply is ok, the filter cartridge must be exchanged.
sieve in tank (below the water filter) is blocked
Remove the water filter to clean the sieve!
appliance placed aslant (not levelled out)
Search for a horizontal space!
powder is pressed too firmly or irregular
The correct compacting pressure is ca. 15 kg!
air in the system
Bleed the system by dispensing hot water!
appliance is calcified
Decalcify the appliance according to instructions!
portafilter drips
no fault
This is a normal process – place a vessel below when removing the cup!

Related product manuals