4-2
Model 1199 Diaphragm Seal Systems Manual
Return of Materials
Within the United States, call the Rosemount North American Response
Center using the 1-800-654-RSMT (7768) toll-free number. This center,
available 24 hours a day, will assist you with any needed information or
materials.
Outside of the United States, contact the nearest Rosemount Diaphragm
Seal Support Center, or contact your local Rosemount representative
(Support Center addresses and phone numbers are on the title page of this
manual).
The center will ask for product model and serial numbers, and will provide a
Return Material Authorization (RMA) number. The center will also ask for
the name of the process material the product was last exposed to.
00806-0201-4016
English
January 1997
TABLE 4-1. (continued).Troubleshooting Seal Systems.
WILL NOT ZERO
Symptom
Potential Source Corrective Action
Will not zero Transmitter position
O-Ring position
Air under diaphragm
Elevation/suppression jumper
Check for over-ranging transmitter.
Make sure O-ring is not in contact with sensing diaphragm.
Check for over-ranging transmitter.
See the “Zero Adjustment Range” information in the Calibration section of the
(analog transmitters only).
.
Mishandling products exposed to a hazardous substance
can cause death or serious injury. If the product being
returned was exposed to a hazardous substance as defined
by OSHA, a copy of the required Material Safety Data Sheet
(MSDS) for each hazardous substance identified must be
included with the returned goods.
To Next Page
Loading...
