Rosemount 54E - Default Chapter; Table of Contents

MODEL 54e pH/ORP TABLE OF CONTENTS
MODEL 54E PH/ORP
MICROPROCESSOR ANALYZER
TABLE OF CONTENTS
Section Title Page
1.0 DESCRIPTION AND SPECIFICATIONS ................................................................ 1
1.1 General Description ................................................................................................ 1
1.2 Description of Controls............................................................................................ 1
1.3 Specifications.......................................................................................................... 2
1.4 Ordering Information ............................................................................................... 4
2.0 INSTALLATION....................................................................................................... 5
2.1 Locating the Controller............................................................................................ 5
2.2 Unpacking and Inspection...................................................................................... 5
2.3 Mechanical Installation............................................................................................ 5
3.0 WIRING ................................................................................................................... 7
3.1 General.................................................................................................................... 7
3.2 Power Input Wiring .................................................................................................. 7
3.3 Analog Output Wiring.............................................................................................. 7
3.4 Alarm Relay Output Wiring...................................................................................... 7
3.5 pH Sensor Wiring .................................................................................................... 9
3.6 Final Electrical Check.............................................................................................. 12
4.0 CALIBRATION ........................................................................................................ 13
4.1 Temperature Calibration .......................................................................................... 14
4.2 Automatic Two-Point Calibration ............................................................................. 15
4.3 Manual Two-Point Calibration.................................................................................. 17
4.4 Single-Point pH Calibration ..................................................................................... 18
4.5 Compensation Options............................................................................................ 19
4.6 pH Slope Adjustment .............................................................................................. 19
4.7 Hold Mode............................................................................................................... 20
5.0 SOFTWARE CONFIGURATION ............................................................................. 21
5.1 Changing Alarm Setpoints ...................................................................................... 25
5.2 Changing Output Setpoints (PID only).................................................................... 26
5.3 Changing Output Setpoints (Normal)...................................................................... 27
5.4 Testing Outputs and Alarms.................................................................................... 28
5.5 Choosing Display Options....................................................................................... 30
5.6 Changing Output Parameters ................................................................................. 32
5.7
Changing Alarm Parameters................................................................................... 35
5.8 On-Line Diagnostics Setup ..................................................................................... 41
5.9 Auto Calibration Setup ............................................................................................ 42
i