RosRoca Dennis Eagle Olympus - Lubrication

6
6‑5
SCHEDULED MAINTENANCE
OL1D-SM-GB02D
2883-OL1-D-GB-G2
A
2
3
1
2
Fig. 6-1 Bodywork lubrication points
6.6 Lubrication
1. Immobilise the vehicle (see ‘1.2 Immobilising
the vehicle prior to service procedures’ on page
1‑3).
2. Remove the bolts securing the bottom of the
packer plate pivot cover plates. Loosen the top
bolts and open each cover (see Fig. 6‑1, A).
3. Start the engine.
4. Energise the compaction mechanism control
panels.
5. Press and release the ‘Start pack cycle’ push‑
button.
6. When the grease nipple is visible in the access
hole, press an ‘Emergency stop’ push‑button.
7. Reset the ‘Emergency stop’ push‑button.
8. Immobilise the vehicle (see ‘1.2 Immobilising
the vehicle prior to service procedures’ on page
1‑3).
9. Clean the following mechanisms and lubricate with
clean oil:
• Side door hinges (see Fig. 6‑1, 1).
• Side door budget locks (see Fig. 6‑1, 2).
10. Clean the following mechanisms and lubricate with
grease:
• Carriage plate/Packer plate bearings (2
nipples) (see Fig. 6‑1, 3).