RosRoca Dennis Eagle Olympus - Compaction Mechanism Cycle Time Check; Hand Wash Unit (Optional Item); Operational Check; Power Take-Off Propeller Shaft (if Fitted)

6
6‑12
SCHEDULED MAINTENANCE
OL1D-SM-GB02D
6.9.8 Compaction mechanism
cycle time check
Check the compaction mechanism cycle time as
follows:
1. Start engine.
WARNING:
MAKE SURE THAT ALL PERSONNEL ARE
CLEAR OF THE BODY, TAILGATE AND REAR
OF THE VEHICLE.
2. Energise the compaction mechanism control
panels (see Operator’s handbook, ‘Energising the
control panels’).
3. Depress the ‘Start pack cycle’ push‑button on the
compaction mechanism control panel to activate
packing cycle and leave in the fully packed
position.
4. Depress the ‘Start pack cycle’ push‑button on the
compaction mechanism control panel again and
time one complete cycle ‑ it should be between 18
to 20 secs (Body & hopper empty).
2774-OL1-D-GB-G1
2877-OL1-D-GB-G1
BA
C
6.9.5 Power Take-Off propeller
shaft (if fitted)
1. Examine the power take‑off propeller shaft
universal joints for security, worn bearings, damage
to grease seals and cracks.
2. Examine the power take‑off propeller shaft flange
nuts for security and condition.
3. Examine the power take‑off propeller shaft slider
joint and grease seal for wear and damage.
6.9.6 Hand wash unit (optional item)
1. Check the hand wash unit for, security of mounting,
damage, corrosion and leaks.
2. Check that it operates to specification.
6.9.7 Operational check
1. Unprop the tailgate (see Operator’s Handbook).
2. Carry out a full operational check of the body and
tailgate systems as described in Chapter 3 ‑ ‘Daily
checks’.
3. Check that all lamps and warning lamps emit light
of the correct colour, do not flicker and that their
illumination is not affected by the operation of any
other lamp or equipment.
4. Check that the audible warning devices, if fitted,
emit sounds correct to specification.