Ross NK Series - Page 27

NK-VRC User Guide (v05) Setting Up the NK-VRC • 27
Figure 4.10 The Edit Source/Destination Mappings dialog box: range of selected cells
To edit a mapping table
1. In the Physical Map tab, click Edit.
The Edit Source/Destination Mappings dialog box opens.
2. In the Ta ble section, select a radio button to edit Destinations or Sources.
3. In the Levels section, use the level check boxes to select the levels to populate with mapping information.
4. In the Range section, enter the cell range in which to enter mapping information.
For example, if populating the cells from virtual number 12 to virtual number 108, enter
12 in the Start field
and
108 in the End field.
5. In the Va lue section, use the text box to enter the value to use in the first virtual number cell.
For example, if the value in the first selected cell is to be 53, enter
53.
6. Perform one of the following:
• to fill the range with the same number in each cell, clear the Increment check box.
• to fill the range with incrementing values, select the Increment check box.
• to clear the range, select the Blank check box.
For example, if you increment the value of 53 across the virtual number range of 12 to 108 on L3, then cell
L3/12 will have a value of 53, and cell L3/108 (on page 2) will have a value of 149. The cells in between will
have a sequential value.
7. Click
Fill.
The Edit Source/Destination Mappings dialog box closes and the mapping table is updated to reflect the
changes.
8. Click
Send Configuration (see “Sending the Configuration to a Device” on page 21).
 All cells in the physical mapping table are populated by default.