AC-015 Page 7 March 2008
Secure modes of operation. Employees 11 to 500,
when entered from the external reader sensor, may
only operate the system in both the Normal and
Bypass modes of operation.
It is very important to keep an accurate record of the
slot number and its assignment to each employee.
This is to enable you to add additional employees at a
later time or delete a Prox. or PIN code if one is lost or
stolen. A record form is enclosed for your reference to
assist you with your record keeping.
The AC-015 is capable of learning both PIN codes
(keyboard based codes - 4 digit codes) and Proximity
codes (received from proximity card reader). The
system can be connected to up to two reader
sensors. An external reader is to be located outside
the restricted area, and it is always required. The
second reader is for internal installation. Readers need
to be Wiegand 26 bits interface type, and may be a
Proximity card reader (for Prox. codes), Keyboard (for
PIN type codes) or combined PIN/PROX reader.
For more information please refer to Accessories –
page 47.
A PIN reader, connected to indoor reader input, can
perform all the operations usually performed from the
on-board keyboard (depending on the PIN reader
model). A PIN reader connected to an external
reader input will behave similarly, but access level is
different on certain AC-015 status of operation.
Topics in this section:
• Key Features
• Technical Specifications
To Next Page
Loading...
Need help?
General
