AC-015 Page 12 March 2008
Mounting the Controller
1) Before starting, select the location for mounting
the AC-015 controller. The controller should be
installed indoors and within the premises to be
secured. It is recommended that the controller be
installed where it cannot be seen for increased
security, but still close enough to the doors so that
the controller’s annunciator (Door Bell, Chime &
Siren) can be heard. When selecting a location,
take into consideration how the controller will be
attached to a PC for easier programming and
system maintenance.
2) Find the mounting template label that is provided
in your AC-015 packaging, and place it at the
location that you wish to install the controller. The
template is designed to assist you through the
mounting procedure, showing you where you drill
holes in the wall to pass the wiring through and
where the wall must be drilled to insert the
controllers mounting screws.
3) (Skip this step when attaching the AC-015 to a US
Gang Box)
Drill a hole for cables as indicated on the wiring
template. Two hole sizes are shown to allow for the
amount of cables needed, depending on
installation requirements or adding a backup
battery. Drill two screw holes for mounting the AC-
015 to the wall.
4) Remove the case screw from the controller (see
diagram below to locate the case screw) and
remove the front case from the controller.
5) Mount the controller to the wall using the two
screws provided in the Installation Kit or use the
To Next Page
Loading...
Need help?
General
