Programming
24 AC-x32 Series Installation and Programming Manual
5.1 Entering Programming Mode
The controller must be in Normal mode to enter the
Programming mode.
The factory default Programming code is 1234.
If a Programming code is not entered within five seconds, the
unit returns to Normal mode.
To enter Programming mode:
1. Press # for two seconds.
The Mode LED turns off and the Door
LED turns red.
2. Enter your 4-digit Programming code.
If the Programming code is valid, the
Door LED turns green and the unit
enters Programming mode.
5.2 Exiting Programming Mode
Wrong entries may reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for one
minute, the unit exits Programming mode and returns to Normal
mode.
In certain Programming modes, a quick press on # may also
return the system to Normal mode.
To exit Programming mode:
1. Press # for two seconds.
Three beeps are emitted.
The Door LED turns off.
The Mode LED turns green, indicating that
the unit has returned to Normal Mode.
To Next Page
Loading...
Need help?
General
