Rosslare AC-G44 - From Normal to Bypass Mode; From Bypass to Normal Mode

Operation
AC-F/G4x Series Installation and Programming Manual 27
2.
Press # to confirm the mode change.
The left LED stops flashing.
The auxiliary input of the controller can also be used to switch
the mode of operation from secure to normal and vice versa, if
the auxiliary input is selected it de-activates the Norma/Secure
mode code (see Section 5.9).
4.3.3 From Normal to Bypass Mode
By default, there is no Normal/Bypass code. The Normal/Bypass
code must first be programmed to use this function (see Section
5.7 to create/modify the Normal/Bypass code).
To change from Normal to Bypass mode:
1.
Enter the 4-digit Normal/Bypass code.
The left LED flashes orange.
2.
Press # to confirm the mode change.
The left LED stops flashing.
4.3.4 From Bypass to Normal Mode
To change from Bypass to Normal mode:
1.
Enter the 4-digit Normal/Bypass code.
The left LED flashes green.
Green
Orange
Orange
Green