Table of Contents
iv AYC-Ex5/T65 Series Installation and Programming Manual
4.2.1 Normal Mode ....................................................................................31
4.2.2 Bypass Mode ....................................................................................31
4.2.3 Secure Mode .....................................................................................32
4.2.4 Changing the Modes of Operation .................................................32
4.3 Auxiliary Input and Output ....................................................... 34
4.4 Door Alarms ............................................................................. 34
4.5 Internal Case and Back Tamper .............................................. 34
4.6 Lockout Feature (Keypad Tamper) .......................................... 34
4.7 REX Function ........................................................................... 35
4.8 Secured Intelligent Power Supply ............................................ 35
4.9 Programming as a Controller .................................................. 36
4.9.1 Entering Programming Mode ..........................................................37
4.9.2 Exiting Programming Mode ............................................................37
4.9.3 Changing Lock Strike Code .............................................................38
4.9.4 Changing Auxiliary Code..................................................................38
4.9.5 Changing the Programming Code ..................................................39
4.9.6 Changing the Normal/Secure Code ...............................................40
4.9.7 Changing the Normal/Bypass Code and Door Chime Settings ...40
4.9.8 Setting Fail Safe/Secure Operation, Tamper Siren and Lock Strike
Release Time ....................................................................................41
4.9.9 Defining the Auxiliary Input and Output .........................................43
4.9.10 Setting the Lockout Feature ............................................................48
4.9.11 Setting the Backlight Behavior ........................................................49
4.9.12 Enrolling Primary and Secondary Codes........................................50
4.9.13 Deleting Primary and Secondary Codes ........................................54
4.9.14 Relay Codes Assignment.................................................................56
4.9.15 PIN Code Length/Factory Default Settings ...................................59
4.9.16 Replacing a Lost Programming Code ............................................59
To Next Page
Loading...
