Controller Operation
AYC-Ex5/T65 Series Installation and Programming Manual 31
Secure
A Secure user must have a Primary and Secondary code
programmed; the two codes cannot be the same. The Secure
user can gain access when the unit is in any of its three modes
of operation. In Normal mode, the Secure user must use the
Primary code to gain entry. In Secure mode, the Secure user
must present both the Primary and Secondary codes to gain
entry.
Master
A Master user must have both Primary and Secondary codes
programmed with the same PIN code. The Master User can
gain access during any mode of operation by presenting the
PIN code and/or proximity card one time to the controller. (The
Master user is convenient but is less secure than a Secure
user.)
4.2 Modes of Operation
There are three modes of operation:
4.2.1 Normal Mode
The left LED is green.
Normal mode is the default mode. In Normal mode the door is
locked until a Primary code is presented to the controller. Special
codes such as Lock Strike code and Auxiliary code are active in
Normal mode. See Sections 4.9.3 and 4.9.4 for more information
on the Lock Strike and Auxiliary codes.
4.2.2 Bypass Mode
The left LED is orange.
In Bypass mode, access to the premises is dependent on whether
the controller's Lock Strike Relay is programmed for Fail Safe
Operation or Fail Secure Operation. When the Lock Strike is
To Next Page
Loading...
Need help?
General
