Controller Functionality
AYC-Fx4 and AYC-Gx4 family manual Page 29
6.2.2. Bypass Mode
MODE LED is orange
In Bypass Mode, access to the premises is dependent on whether
the controller's Lock Strike Relay is programmed for Fail Safe
Operation or Fail Secure Operation. When the Lock Strike is
programmed for Fail Secure Operation, the door is locked until the
"*" button is pressed. When the Lock Strike is programmed for Fail
Safe Operation, the door is constantly unlocked.
6.2.3. Secure Mode
MODE LED is red
Only Secure and Master Users can access the premises during the
Secured Mode.
A Secure User must enter their Primary and Secondary Codes to
gain entry. After entering their Primary Code the Door LED will flash
green for 10 seconds, during which the Secondary Code must be
entered. A Master User only needs to present their code once to
gain entry.
6.2.4. Changing the Modes of Operation
Changing from Normal Mode to Secure Mode
The default factory setting for the Normal / Secure code is 3838.
1) Enter the Normal / Secure
code
• Mode LED will flash red
2) Press the “#” key to confirm
the mode change.
• Mode LED will turn red
To Next Page
Loading...
Need help?
General
