Issue 1 Original Version October 2014
- 7 -
5) SPECIFICATION
Maximum hole cutting capacity in .2/.3C steel = 40mm dia. x 50mm deep
Arbor bore = 19.05mm (3/4”) dia.
Total Normal Full Load (magnet + motor)
Height (maximum extended)
Width (including Hand Wheel)
Length Overall (including Guard)
Tractive Force of Magnet at 20º C (25mm min. plate thickness)
The use on any material less than 25mm thick will progressively reduce the
magnetic performance. If possible substitute material should be positioned under
the magnet and work piece to equate to a suitable material thickness. If this is not
possible an alternative secure method of restraining the machine MUST be used.
Failure to do so may result in personal injury.
Maximum hand/arm vibration magnitude (measured at handle during operation in
accordance with ISO5349, using a 22mm dia cutter through a 13mm mild steel plate).
Estimate of vibration exposure. Operation 30 holes @ 1 minute/hole.
Average noise level during cutting at operator’s ear position.
Ear and eye defenders must be worn when operating this machine. Wear gloves to protect hands
when operating the machine.
These tools are UK designed and manufactured with globally sourced components and conform with
the requirements of EEC Document HD.400.1 and BS.2769/84
Suitable only for a single phase 50-60Hz A.C. power supply
DO NOT USE ON D.C. SUPPLY
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will earth back through the magnet and cause irreparable damage.
WARNING: THIS APPLIANCE MUST BE EARTHED!
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE GUARANTEE
To Next Page
Loading...
