15
Emergency (no power) Lowering:
Pull To
Release
Lock
NOTE: Top cover not shown for clarity.
Manual Lowering
Valve
• During lowering of lifts, ensure that vehicle does not
move into an inclined position.
• Lower columns equally.
• Remove tool trays, safety stands, etc. from area.
• Remain clear of forks and vehicle when lowering.
NOTE: In the event batteries become fully discharged, plug
the columns into electrical outlet for approximately 15
minutes to achieve adequate charge for one operation
cycle. Length may vary based on battery type,
condition, etc.
A. Remove M8 BHCS and open Power Unit Cover. Pull
lock open. Push the Manual Lowering Valve Button and
the carriage will begin lowering.
C. If lift is on locks, slightly lift carriage until lock is free.
D. Lower each carriage a small increment at a time
keeping the vehicle level.
E. Release the Manual Lowering Valve Button and the
downward movement will stop.
F. After lowering is finished, close and re-install M8 BHCS
in Power Unit Cover.
G. If lift is not operating properly, Do Not use until
operation is corrected or repairs are made by qualified
lift service personnel.
To Next Page
Loading...
Need help?
General
