------------------------------
-
----------
-3
when
moving
the
cart/
apparatus combination
to
avoid injury
from tip-over.
Unplug this apparatus during lightning storms or when unused
for long periods
of
time.
Refer all servicing
to
qualified service personnel. Servicing
is
required
when
the
apparatus has been damaged in any
way,
such
as
power supply cord
or
plug
is
damaged, liquid has been
spilled
or
objects have fallen
into
the
apparatus,
the
apparatus
has been exposed to rain or moisture, does
not
operate normally,
or
has been dropped.
The apparatus should be used in non-tropical climate.
The
ventilation
should
not
be
impeded
by
covering
the
ventilation openings
with
items, such
as
newspapers, table-
cloths, curtains, etc.
No naked flame sources, such
as
lighted candles, should be
placed on
the
apparatus.
Touching
uninsulated
terminals
or
wiring
may
result in an
unpleasant sensation.
You
must
allow a
minimum
10
cm
or
4 inches
of
unobstructed
clearance around
the
unit.
WARNING: The rear panel power cord connector
is
the
mains
power disconnect device. The device
must
be located in an
open
area
that
allows access
to
the
cord connector.
The
unit
must
be connected
to
a power
supply
only
of
the
type and voltage specified on
the
rear panel.
{USA:
120
V/60Hz,
EC:
230V/50Hz)
CAUTION: The rear panel includes an
AC
voltage
selection
switch. Confirm
this
switch
is
set
to
the
proper
AC
voltage
before attaching
the
power cord.
Connect
the
component
to
the
power
outlet
only
with
the
supplied power supply cable or an exact equivalent. Do
not
modify
the
supplied cable. Do
not
use extension cords.
The
mains
plug
is
the
disconnect
of
the
unit.
In
order
to
completely disconnect
the
unit
from the supply mains, remove
the
main plug from
the
unit
and
the
AC
power outlet. This
is
the
only way
to
completely remove mains power from
the
unit.
Use
Class
2 wiring for speaker connections
to
ensure proper
installation and minimize
the
risk
of
electrical shock.
The batteries in
the
remote
control
should
not
be exposed
to
excessive temperature such
as
sunshine, fire
or
other
heat
sources. Batteries should be recycled
or
disposed
as
per state
and local guidelines.
WARNING: The
master
power
switch
is
located on
the
rear
panel. The
unit
must
allow unobstructed access
to
the
main
power switch.
FCC
Information
This
equipment
has been tested and found
to
comply
with
the
limits for a
Class
B digital device, pursuant
to
Part
15
of
the
FCC
Rules.
These
limits
are
designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment
generates, uses and can radiate radio frequency
energy
and,
if
not
installed
and
used
in
accordance
with
the
instruction,
may
cause
harmful
interference
to
radio
communications.
However, there
is
no
guarantee
that
interference will
not
occur
in a particular installation. If this
equipment
does cause harmful
interference
to
radio
or
television reception,
which
can be
determined by
turning
the
equipment
off
and on,
the
user
is
encouraged
to
try
to
correct
the
interference by one or
more
ofthe
following measures:
• Reorient or relocate
the
receiving antenna.
('TV,
radio, etc.).
-Increase
the
separation between
the
equipment
and receiver.
• Connect
the
equipment
to
an
outlet
on circuit different
from
that
to
which
the
receiver
is
connected.
• Consult the dealer or
an
experienced radio/TV technician for
additional help.
Caution
This device complies
with
part
15
of
the
FCC
Rules. Operation
is
subject
to
the
following
to
conditions:
(1)
This device
may
not
cause harmful interference, and
(2)
this device
must
accept any
interference received, including interference
that
may
cause
undesired operation.
NOTE
TO
CATV
SYSTEM
INSTALLER:
Call
the
CATV
system or
antenna installer's attention
to
Article 820-40
of
the
NEC.
This
provides guidelines for proper
grounding
and, in particular,
specifies
that
the
cable
ground
shall
be
connected
to
the
grounding
system
of
the
building,
as
close
to
the
point
of
cable
entry
as
practical.
See
installation diagram.
NOTE: This
equipment
has been tested and found
to
comply
with
the limits for a
Class
B digital device, pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed to provide reasonable
protection against interference in a residential installation. This
equipment
generates and can radiate radio frequency energy
and, if
not
installed and used in accordance
with
the instructions,
may
cause interference
to
radio
or
TV
communications. There
is
no
guarantee
that
interference will
not
occur in a particular
installation. If this
equipment
does cause interference
to
radio
or television reception,
which
can be
determined
by
turning
the
equipment
off
and on,
try
to
correct
the
interference by
one
or more
of
the
following measures:
• Reorient or relocate
the
receiving antenna.
• Increase
the
separation between
the
unit
and
the
television
tuner.
•
Connect
the
unit
to
an
AC
power
outlet
on
a
different
electrical circuit.
• Consult your authorized
Ratel retailer for assistance.
ANTENNA GROUNDING ACCORDING
TO
NATIONAL ELECTRtcAL
CODE
INSTRUCTIONS
SECTION
110: "RADIO AND TELEV1stON EQUIPMENT"'
FCC Information
Caution
�
To Next Page
Loading...
