1 x Safety
5
BA ROTEX A1 BO - 10/2007
Validity
Some information in this manual has limited validity. The validity is highlighted by a symbol.
Order number
Notes related to Order numbers are identified by the cart symbol .
Handling instructions
• Instructions on actions are shown as a list. Actions of which the sequential order must be maintained are numbered.
Î Results of actions are identified with an arrow.
1.3 Avoid danger
ROTEX oil condensing boilers are state-of-the-art and are built to meet all recognised technical requirements. However, improper
use can lead to serious injuries or death, as well as causing material damage. To avoid danger, install and operate ROTEX oil
condensing boilers only:
– as stipulated and in perfect condition,
– with an awareness of the safety and hazards involved.
This assumes knowledge and use of the contents of this manual, the relevant accident prevention regulations and the recognised
safety-related and occupational medical rules.
1.4 Proper use
The oil condensing boiler ROTEX A1 BO xxi can only be used for heating hot water heating systems. It must be installed,
connected and operated only according to the information in this manual.
The oil condensing boiler ROTEX A1 BO xxi may be operated only in combination with a control unit approved by ROTEX
(see conformity declaration on page 2 of this manual).
The oil condensing boiler ROTEX A1BO may be operated only with the integrated circulation pump.
Any other use outside the above-mentioned use is considered as improper. Any resulting damages will be borne by the user/owner
alone.
Intended use also includes compliance with the maintenance and service conditions. Spare parts must at least satisfy the
technical requirements defined by the manufacturer. This is the case, for example, with original spare parts.
Valid only for ROTEX Control ALPHA 23R
Valid only for ROTEX Control THETA 23R
a
q
To Next Page
Loading...
Need help?
General
