A4 US
US
A4
US
A4
A4 US
Redefining Flow Control
3
1 - Introduction
Actuators used in many industries sometimes
have to be mounted in places where it is
hazardous, inconvenient or just unpleasant for
a human to operate. In these cases it is useful to
be able to see the status and locally operate an
actuator from a safe distance.
Typically in this situation you would be faced with a simplistic
interface for basic operation and indication, however Rotork’s
enhanced solution allows the user to have an exact replication
of the actuator interface.
Using the same display and controls interface from the
IQ 3
rd
generation actuator, users can remotely operate,
interrogate and configure the IQ actuator from up to 100 m
distance. Due to the familiar, feature rich interface, set up
couldn’t be simpler using the Rotork Bluetooth
®
Setting Tool
Pro supplied with the IQ.
Retaining the full functionality of the IQ, dataloggers can be
viewed and downloaded locally at the Remote Hand Station
(RHS) instead of gaining access to the actuator. Power for
the RHS is supplied by the actuator, removing the need for
supplementary power supplies.
The following instructions must be followed and integrated
with your safety program when installing and using Rotork
Controls products:
• Read and save all instructions prior to installing, operating
and servicing this product.
• If you don’t understand any of the instructions, contact
Rotork Controls for clarification.
• Follow all warnings, cautions and instructions marked on,
and supplied with, the product.
• Inform and educate personnel in the proper installation,
operation and maintenance of the product.
• Install equipment as specified in Rotork Controls
installation instructions and per applicable local and
national codes. Connect all products to the proper
electrical sources.
• To ensure proper performance, use qualified personnel to
install, operate, update and maintain the unit.
• When replacement parts are required, ensure that the
qualified service technician uses replacement parts
specified by Rotork Controls. Substitutions may
result in fire, electrical shock, other hazards, or improper
equipment operation.
• Keep all product protective covers in place (except
when installing, or when maintenance is being performed
by qualified personnel), to prevent electrical shock,
personal injury or damage to the product.
• Operation of product in an inappropriate fashion
may cause harm or damage to unit or other equipment
surroundings.
To Next Page
Loading...
Need help?
General
