EasyManuals Logo

Royal Enfield Bullet 500 User Manual

Royal Enfield Bullet 500
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
79
EMISSION WARRANTY
In compliance with the provisions of Rule 115(2) of the Central Motor Vehicle Rules, 1989, Royal Enfield certifies
that the following warranty is applicable to those components liable to affect the emission of the gaseous pollutants
in its range of motorcycles, in normal use to which it may be subjected to.
This emission warranty comes into force from 01st July 2001 and is valid for a period of 30,000 Kms. or 36 months,
whichever occurs earlier, from the date of sale to the first customer and is in addition to and parallel to the
warranty policy, conditions and obligations laid down in the Owner’s Manual.
Royal Enfield further warranty that if on examination by its Authorised Dealer / Service Point, the motorcycle fail to
meet the specified emission standards, then the Authorised Dealer / Service Point shall take necessary corrective
measures and shall at its sole discretion, repair or replace free of charge such components of the emission control
system to meet the required emission standards.
The method/s of examination to determine the warranty conditions of the emission warranty related components
will be at the sole discretion of Royal Enfield and / or our Authorised Dealer / Service Point and results of such
examination will be final and binding. If on examination the warranty conditions of the part/s is/are not established,
Royal enfield will have the right to charge all, or part of the cost of such examination to the customer in addition
to the cost of the components.
In case of acceptance of the component/s under Emission warranty, Royal Enfield will replace free of charge, the
component/s as required. However, the consumables like fuel, lubricants, solvents, etc shall be chargeable to the
customer as per actual.
In case any of the components covered under emission warranty or the associated parts, are not independently
replaceable. Royal Enfield will have the sole discretion to replace either the entire assembly or parts of the assembly,
through suitable repairs.
Royal Enfield reserves the right to carry out necessary consequential repairs to the motorcycle or replace any
part, in addition to the repair or replacement of the components covered under emission warranty, to establish
compliance to in-use emission standards. Such repairs / replacements will be chargeable to the customer.

Table of Contents

Questions and Answers:

Royal Enfield Bullet 500 Specifications

General IconGeneral
Engine TypeSingle Cylinder, 4 stroke, Air cooled
Displacement499 cc
Bore x Stroke84 mm x 90 mm
Compression Ratio8.5:1
Maximum Power27.2 bhp @ 5250 rpm
Maximum Torque41.3 Nm @ 4000 rpm
Fuel SystemElectronic Fuel Injection
ClutchWet, multi-plate
Transmission5 Speed Constant Mesh
Frame TypeSingle downtube, using engine as stressed member
Front SuspensionTelescopic, 35 mm forks, 130 mm travel
Front Brake280 mm Disc, 2-Piston caliper
Rear Brake153 mm Drum, Single Lead Internal Expanding
Front Tyre90/90 - 19
Rear Tyre120/80 - 18
Kerb Weight194 kg
Seat Height800 mm
Ground Clearance135 mm
Wheelbase1370 mm
Ignition SystemTransistorised Coil Ignition (TCI)
Rear SuspensionTwin shock absorbers with 5-step adjustable preload
Fuel Tank Capacity13.5 L

Related product manuals