Do you have a question about the Royal Enfield BULLET ELECTRA and is the answer not in the manual?
Displacement | 346 cc |
---|---|
Max Power | 19.8 bhp @ 5250 rpm |
Max Torque | 28 Nm @ 4000 rpm |
Fuel System | Carburetor |
Gearbox | 5 Speed Constant Mesh |
Front Suspension | Telescopic, 35mm forks, 130mm travel |
Rear Suspension | Twin shock absorbers with 5-step adjustable preload |
Ground Clearance | 135 mm |
Seat Height | 800 mm |
Clutch | Wet multi-plate |
Front Brake | 280 mm Disc |
Rear Brake | 153mm |
Fuel Tank Capacity | 13.5 liters |
Ignition | Electronic Ignition (T.C.I) |
Technical details of the engine and its components.
Information about the gearbox and gear ratios.
Details on the motorcycle's frame, suspension, and brakes.
Recommended tyre inflation pressures for solo and pillion riding.
Specifications for the motorcycle's electrical system components.
Kerb weight and maximum payload capacity.
Physical measurements of the motorcycle.
Guidelines for appropriate riding attire and safety gear.
Recommendations for maintaining a stable and safe riding posture.
Instructions on effective braking techniques and warnings.
Location of the motorcycle's unique frame identification number.
Location of the motorcycle's unique engine identification number.
Identification of key parts visible from the top of the motorcycle.
Identification of key parts visible from the left side of the motorcycle.
Identification of key parts visible from the right side of the motorcycle.
How to operate the main ignition switch for starting and stopping.
Procedure for opening and closing the fuel tank cap.
Instructions for accessing and opening the side storage compartment.
How to open and access the battery compartment.
How to engage and disengage the steering lock for security.
Operation of the horn button.
Procedure for starting the engine using the electric starter.
Operation of the headlight switch for different lighting modes.
How to use the engine stop switch to turn off the engine.
Control for switching between high and low beam headlights.
Operation of the turn signal indicators for left and right turns.
How and when to use the choke for cold starts.
Operation of the fuel tap for main supply and reserve.
Step-by-step guide for starting the motorcycle using the kick starter.
Step-by-step guide for starting the motorcycle using the electric starter.
Instructions for parking the motorcycle securely on its center stand.
Instructions for parking the motorcycle securely on its side stand.
Lubrication and maintenance of control cables and pivot points.
Procedures for checking oil levels, brake fluid, and drive chain.
How to clean/adjust spark plugs and inspect tyres.
Checking tyre pressure and removing the front wheel.
Step-by-step process for reassembling the front wheel.
Step-by-step process for removing the rear wheel.
Reassembling rear wheel and adjusting brake pedal height.
Adjusting rear brake and drive chain tension.
Aligning wheels and adjusting rear shock absorber.
Procedure for safely removing the motorcycle battery.
Maintaining battery and reinstalling it.
Changing headlight bulb and removing the headlamp.
Replacing tail lamp, indicator bulbs, and fuses.
Safety and preparation steps before washing the motorcycle.
Steps to follow after washing for drying and protection.
Steps for getting the motorcycle ready after storage.
Pre-trip checks to ensure the motorcycle is ready.
Regular checks recommended during long trips.
Preventing fuel leaks and using recommended fuels/oils.
Tips for cost-effective riding and preventive maintenance.
Reducing fuel waste from idling and avoiding brake/clutch riding.
Techniques to improve mileage by managing braking and load.
Advice on parking the vehicle to minimize fuel evaporation.
Common causes and remedies for engine start issues.
Causes and remedies for engine misfiring problems.
Troubleshooting engine starting, running, and stopping issues.
Causes and remedies for lack of acceleration and power.
Diagnosing and fixing issues causing white or blue smoke.
Causes and remedies for engine overheating.
Identifying reasons for high fuel usage.
Causes and remedies for ignition knock in the engine.
Troubleshooting issues related to ineffective braking.
Diagnosing and fixing causes of vehicle wobbling.
Troubleshooting common electrical component failures.
Diagnosing issues with the electric start system.