Why aren't the rollers turning on my Royal Sovereign Laminator after pressing the 'RUN' button?
If your Royal Sovereign Laminator has power but the rollers aren't turning after you press the 'RUN' button, it could be due to a few things. Check if the emergency switch is engaged and disengage it. Ensure the paper guide is correctly installed so the micro switch is activated. Also, inspect the motor fuse and replace it if blown.
What to do if my Royal Sovereign RSC-1400C Laminator won't turn on?
If your Royal Sovereign Laminator isn't turning on, there could be a few reasons. First, check that the power cord is securely plugged into the outlet. Next, make sure the power switch is in the 'I' (On) position. If it still doesn't work, check the circuit breaker and reset it if necessary. Finally, inspect the main power fuse and replace it if it's blown.
How to fix curled lamination on Royal Sovereign RSC-1400C?
To fix curled lamination with your Royal Sovereign Laminator: * If the lamination is curling upwards, loosen the top roll film tension. * If the lamination is curling downwards, loosen the bottom roll film tension.
General| Model | RSC-1400C |
|---|---|
| Category | Laminator |
| Maximum Width | 14 inches |
| Maximum Thickness | 10 mil |
| Roller Number | 2 |
| Carrier | No |
| Hot and Cold Lamination | Yes |
| Type | Roll |
| Laminating Thickness | 3 mil to 10 mil |
| Roller Type | Silicone |
| Warm-up Time | 3-6 minutes |
To Next Page
