To Next Page
B
brian19Jul 25, 2025
What to do if Royal Sovereign RSC-6500H Laminator rollers are not running?
- SSally DiazJul 26, 2025
If the rollers on your Royal Sovereign laminator aren't running, there could be several reasons: * Ensure the power plug is properly connected to a functioning outlet. * Disengage any emergency switches by rotating the knob clockwise. * If the film is jammed, try using the pressure lever and reverse button to un-jam it. * Confirm the front table switch is engaged. * Check the laser sensor to ensure it is in the correct position and free from obstructions. If these steps don't resolve the issue, it may be due to a defective main motor, main PCB, or motor controller. In this case, check if the connector of the wire-motor controller is connected correctly or consider replacing the motor controller.
General
