Royal 101cx - Fixed Tax Rate Programming; How to Program a Fixed Tax Rate

21
TAX RATE (Continued)
__________________________________________________________________
TO PROGRAM A FIXED TAX RATE: (Recommended For Most Applications)
"prg" mode + Tax 1 - 4 + [Tax Shift] + Tax Rate (4 Digit #) + (Amt/Tend/TOTAL)
Note: You can program 1 Tax Rate or up to 4 Tax Rates. Remember, when you determine a department's tax status, at that
point, you identify the tax rate you want for that department.
If you make a mistake between steps 2 and 4, press the Clear [C] key and start again at step 2.
1. Enter the program mode: Move the Control Switch to the "prg" position.
2. Enter (1 - 4) , 1 through 4 being the Tax Rate identifier where that tax percentage will be stored in memory.
3. Press [tax shift] key
4. Enter the Tax Percentage Rate. Up to 5 digits can be used. You MUST enter three digits after the desired decimal
place. For example, to enter 5.5%, type [5500]; to enter 7%, type [7000]; to enter 10.25%, type [10250].
5. Press the [amt tend/TOTAL] key.
Note: If you want to set up another Tax Rate, return to step 2.
Continue with other programming or move the Control Switch out of the Program mode.
Example: Set a tax rate of 5.5% in Tax Rate # 1 and then 8.25% in Tax Rate # 2:
[1] + [tax shift] + [5500] + [amt tend/TOTAL] key
[2] + [tax shift] + [8250] + [amt tend/TOTAL] key