Contents
Starrsed ST Service manual Page 9
Version <Book_version> MRN-<MRN_number>-<language_code>
1.1.1. Chip card type A to E
Chip cards of the types A to E are used to operate the instrument in a pay-per-test scheme. The
chip cards contain a certain amount of credits units. How many tests can be performed with this
amount of credits depends on the configuration which is made by the local <instrument> dealer.
The following amounts of credit units are available:
A 100.000
B 500.000
C 1.000.000
D 5.000.000
E 10.000.000
NOTE:
Available card types and amount of credit units per card may be
subject to changes.
The total amount of credit units on the chip card is transferred to the <instrument> at once and the
chip card is then rendered void. It is not possible to use the same chip card to transfer credits to
more than one instrument.
This type of card is dealer dependent. The instrument only accepts chip cards of the dealer to
which the instrument is configured.
1.1.2. Chip card type I
Chip cards of type I ("Installation card") are used by authorised staff of the dealer to install and
prepare the instrument for the customer. When this type of chip card is inserted in the card reader,
a PIN code must be entered to unlock the protected menus.
1.1.3. Chip card type Q
Chip cards of type Q are used to operate the instrument in ownership without credit limitations and
can only be used on instruments which are configured to accept the Q chip card.
1.1.4. Chip card type R
Chip cards of type R ("Reset card") are exclusively used by authorised staff of the dealer to reset
the credit settings in the instrument to factory defaults. When this type of chip card is inserted in
the card reader, a PIN code must be entered to unlock the protected menus.
To Next Page
Loading...