General introduction
Starrsed ST Service manual Page 17
Version <Book_version> MRN-<MRN_number>-<language_code>
3.1. How to use the Service Manual
In the service manual the following description structure is used to explain an Assembly or Unit.
1. Assembly quick reference to Drawings of the assembly.
This section has the main contents to all other sections in this chapter.
All this assembly drawings are collected in a table.
2. Assembly general information.
All the information what is useful to know to get a better understanding of the assembly.
3. Assembly control with the Menu structure of the software.
In this section all the key functions to control the assembly.
4. Assembly error messages.
All the error messages what is caused by a faulty assembly.
1. Assembly fault symptoms.
All symptoms what can be caused by a faulty assembly.
5. Assembly work instructions.
Instructions for performing often used maintenance procedures.
6. Special tools requirement for this assembly.
List of special not common used tools.
7. Assembly or unit block diagrams.
8. Assembly sensor information.
All the information about the sensors in use by the assembly.
1. How to make the proper sensor adjustment.
2. Assembly label information.
3. Assembly sensor and motor reference.
4. Assembly sensor adjustments.
9. Assembly hardware replacement.
Only hardware replacement is mentioned in this section, like motors and sensor replacement.
10. Assembly hardware adjustment.
When hardware adjustment is required, instructions are mentioned in this section.
11. All trouble shooting on the assembly.
A combination of the Trouble shooting in the User manual of the instrument and extra trouble
shooting on engineer level.
12. Useful and previous information about the assembly.
Extra useful and previous information about hardware and adjustments on the assembly.
13. Applicable drawings from the assembly.
To Next Page
Loading...
