EP Series User Manual
10
Figure 2-5 Output port single-ended input
B. Connect OUT1/OUT2 as sinking type output and connect it to the PLC input, as
shown in Figure 2-6 below.
Figure 2-6 Connect with PLC
C. Connect OUT1/OUT2 as sinking type output and connect it to the relay, as
shown in Figure 2-7 below.
Figure 2-7 Connect with relay
2.5. Network connection and IP address settings
Before you start, please confirm that you have the following fittings.
A stepper motor matching the driver.
A small straight screwdriver for tightening the connector screws.
A computer.
RTConfigurator software(It can be download from: http://www.rtelligent.net/).
A network cable is used for the driver parameter configuration, or for the
connection between the driver and the controller.
To Next Page
Loading...
