EP Series User Manual
13
(2) You should see an icon for your network interface card (NIC). Right-click and
select “Properties”.
(3) Scroll down until you see "Internet Protocol (TCP/IP)." Select this item and click
the "Properties" button. windows 7 and vista, look for "(Transmission Control
Protocol/IP v4)"
(4) Select the option "Use the following IP address". Enter the address
"10.10.10.11". This will give your computer an IP address similar to that of drivers on
the same subnet.
(5) Next, enter the subnet mask as "255.255.255.0".
(6) Be sure to leave "Default Gateway" blank. This will prevent your computer from
looking for routers from this subnet.
(7) Because the driver is directly connected to the computer, your computer will
have a message bubble in the corner of the screen indicating that the network cable is
unplugged when the driver is powered off.
2.5.3. IP setting
The IP setting address format is: IPADD0. IPADD1. IPADD2. IPADD3
Default: IPADD0=192, IPADD1=168, IPADD2=0; The EP series driver has
two10-bit rotary DIP switches, the combination setting is IPADD3 in the IP address,
IPADD3 = (S1*10)+S2+10.
The factory default addresses are listed in Table 2-2 below:
Table 2-2 Factory default address
192.168.0. IP low address
The switch 0 bit is always "10.10.10.10", and is the universal recovery address. If
someone wants to change another IP address but it is not recorded, once the address
is forgotten. Then only through the universal recovery address to connect.
To Next Page
Loading...
