Cool Power
®
Audio Amplier
CP-16i
12
CHAPTER 3 | INSTALLATION AND OPERATION
Controlling the CP-16i
The CP-16i can be powered on and o externally by using the two signals
12V trigger and 3-5V trigger. A Signal Sense function is also provided which
automatically can switch on the CP-16i in the event of an audio signal and
switch o the CP-16i to enter standby mode when no audio signal has been
present on the signal terminals for approximately 13 minutes.
NOTE: Volume control for the CP-16i is managed by an external pre-amp or
audio switcher.
Installation
Mounting the CP-16i into an Equipment Rack
The CP-16i can be mounted in a 19” equipment rack or on a solid at
surface. Use the included removable rack ears and removable feet for
mounting.
Ventilation
NOTE: The maximum operating ambient temperature is 45°C (113°F).
• To ensure that the rack enclosure is adequately ventilated, there must
be a minimum of 3” all around the CP-16i unit.
• Sucient airow must be achieved (by convection or forced-air cooling)
to satisfy the ventilation requirements of all the items of equipment
installed within the rack.
Rack Mount Safety Instructions
• Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
• Consideration should be given to the connection of the equipment to the
supply circuit and the eect that overloading of the circuits might have
on over current protection and supply wiring. Appropriate consideration
of equipment nameplate ratings should be used when addressing this
concern.
• Reliable grounding (earthing) of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections
other than direct connections to the branch circuit (e.g. use of power
strips).
To Next Page
Loading...
Need help?
General
