Need help?Do you have a question about the RTI AD-4x and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Power Output (8 Ohms) | 50W per channel |
| Power Output (4 Ohms) | 75W per channel |
| Audio Inputs | 4 x RCA |
| Audio Outputs | 4 pair speaker binding posts |
Lists crucial precautions and setup instructions for optimal AD-4x performance and safety.
Identifies and describes the functions of each control and connector on the front panel of the AD-4x.
Details the functions of the connectors and controls located on the rear panel of the AD-4x unit.
Explains how to connect remote audio sources using Cat-5 cable and RSP-1 plates.
Describes methods for controlling remote audio sources via IR from an RTI control system.
Details wiring the PDM-1 module to the AD-4x mute input for phone and doorbell integration.
Instructions for connecting speaker wires to the AD-4x phoenix connectors, including polarity.
Details hard-wired IR control setup for the AD-4x using a 3.5mm mini jack and RTI Integration Designer.
Explains how to access and use the AD-4x web interface for setup and adjustments.
Provides steps to find the AD-4x's IP address and access its web interface using a browser.
Details the Network Configuration page for setting static IP addresses or returning to DHCP.
Guides users through configuring individual zones (source, power, mute, volume, group) via the web interface.
Explains how to configure and control groups of zones simultaneously via the web interface.
To Next Page
