18
CHAPTER 3 | INSTALLATION AND OPERATION
CONNECTING AUDIO SOURCES
AD-8
The following diagram shows just one of many possible congurations
when the CP-1650 is connected to an RTI audio distribution system (the
AD-8 audio distribution system is shown here). In this example, CH 1/2
and CH 3/4 on the rear of the CP-1650 have been daisy chained so that
their output goes to different speaker pairs with the same audio feed.
CH 5/6 goes to a separate speaker pair with a separate audio feed.
The channel level adjusters on the rear of the CP-1650 can increase or
decrease the attenuation level going to each speaker pair independently.
CP-1650
Audio
Zone 1
Audio
Zone 1
Audio
Zone 2
Audio
Zone 1
Audio
Zone 2
To Next Page
Loading...
