TRIGGER/CONSTANT SWITCH
When the Trigger Switch is set at “Trigger,” the Power Button toggles the
CP-1650 between the “Standby” and “Off” modes. The 12V DC trigger
toggles the CP-1650 between “Standby” and “On” modes.
When the Trigger Switch is set to “Constant,” press the Power Button to
switch the CP-1650 “On” or “Off.” When the CP-1650 is in “Constant”
mode, both RS-232 and IR can switch the CP-1650 between “Standby” and
“On” modes.
NOTE: The Trigger/Constant switch must be set to the Constant
position for IR control. IR does not work if the switch is in the
Trigger position.
To Next Page
Loading...
