RTK SR-3300 - SR3300 Error and Warning Codes; SR3300 Error Codes; SR3300 Warning Codes; SR3300 Main Software Map

Einbau- und Betriebsanleitung
Installation and Operating instructions
SR3300-8010
SR-3300
Page 30 07/2018
6.3.4
6.3.4.1 Dead-Zone (dEAdZONE) ……………………………………………………
6.3.4.2 P Value (KP) ………………………………………………………………….
6.3.4.3 D Value (Kd) ………………………………………………………………….
6.3.4.4 I Value (KI) …………………………………………………………………….
6.3.4.5 P_(KP_), D_(Kd_), I_(KI_) values……………………………………………
6.3.5 Hand Calibration Mode (HAND CAL) ………………………………………………….
6.3.5.1 Zero-Point (PV_ZERO) and End-Point (PV_END) for Valves ……………
6.3.5.2 Zero-Point (TR_ZERO) and End-Point (TR_END) for Transmitter ……..
6.3.5.3 End-Point Ratio for Valve (PE_TRIM) ………………………………………
6.3.5.4 Normal / Reverse Feedback Signal (TR_NORM / REV) …………………
6.3.5.5 Normal / Reverse HART Signal (HT_NORM / REVS) ……………………
6.3.6 Valve Mode (VALVE) …………………………………………………………………….
6.3.6.1 Acting Adjustment (ACT) ……………………………………………………..
6.3.6.2 Characteristic Adjustment (CHAR) ………………………………………….
6.3.6.3 User Characteristics (USER SET) …………………………………………..
6.3.6.4 Tight Shut Open (TSHUT OP) ……………………………………………….
6.3.6.5 Tight Shut Close (TSHUT CL) ……………………………………………….
6.3.6.6 Split Range Mode (SPLIT) ……………………………………………………
6.3.6.7 Custom Zero Setting Mode (CST ZERO) …………………………………..
6.3.6.8 Custom End Setting Mode (CST ENd) ……………………………………..
6.3.6.9 Interpolation Mode (ITP OFF / ON) ………………………………………….
6.3.7 View Mode (VIEW) ……………………………………………………………………….
7. Error and Warning Code ……………………………………………………………………………….
7.1 Error Code …………………………………………………………………………………………..
7.2 Warning Code ………………………………………………………………………………………
8. Main Software Map ……………………………………………………………………………………..