52 en | Menu Structure DBP Digital Beltpack
2021-06 | 01 | F.01U.380.825
Technical Manual
Bosch Security Systems, LLC
3. Rotate the B/D shaft encoder to make changes.
OR
Rotate the A/C shaft encoder to move to the next octet.
4. Repeat step 3 until the address is complete.
5. Press the SEL/MENU button to confirm the change, or press the CLR/BACK button to
abort changes.
Notice!
Changes to this menu result in a device reboot.
9.1.7 Domain
Use the Domain menu item to configure the domain to which the belt pack belongs.
Validation on address fields occur when you try to save them. If an address is invalid, an error
prompt displays.
To configure the domain, do the following:
1. Navigate to the Domain menu item (Setup | Network | Domain).
2. Press the SEL/MENU button.
The first character position highlights.
3. Rotate the B/D shaft encoder to scroll through available characters.
OR
Rotate the A/C shaft encoder to move to the character for modification.
4. Repeat step 3 until complete.
To Next Page
Loading...
