84 en | Menu Structure DBP Digital Beltpack
2021-06 | 01 | F.01U.380.825
Technical Manual
Bosch Security Systems, LLC
5. Rotate either shaft encoder to select Connect or Disconnect.
6. Press the SEL/MENU button to initiate the action.
A Connecting progress bar appears on the screen. When it finishes the connection, a
Completed message appears on the screen. The connection attempt can also fail
sometimes and shows a red failed message. If this occurs, attempt the connection again.
If disconnecting, a popup window appears with a Disconnected message.
To unpair a Bluetooth headset, do the following:
1. Navigate to the Paired Headsets menu item (Bluetooth | Paired Headsets).
2. Press the SEL/MENU button.
The field is active if Bluetooth devices are available, otherwise the menu item does not
activate.
3. Rotate either shaft encoder to scroll through available devices.
4. Press the SEL/MENU button to confirm.
A popup window appears.
5. Rotate either shaft encoder to select Unpair.
6. Press the SEL/MENU button to confirm the unpairing.
A popup window appears with an Unpaired message.
9.15.3 Paired Aux Devs
The Paired Aux Devs menu item contains a list of phone or other aux devices previously
paired to the DBP. Use this menu item to connect, disconnect, and unpair Bluetooth enabled
devices for use with the belt pack.
To Next Page
Loading...
