ES-2310C User Manual
Publication date: Aug., 2010
Revision A5
113
Function name:
Email Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the
alarm message via email. It depends on your settings. An email address has
to be set in the web page of alarm configuration (See Fig. 3-49). Then, user
can read the trap information from the email. This function provides 6 email
addresses at most. The 21 different trap events will be sent out to SNMP
Manager when trap event occurs. After ticking trap events, you can fill in your
desired email addresses. Then, please click <Apply> button to complete the
alarm configuration. It will take effect in a few seconds.
Fig. 3-49
Parameter description:
Email:
Mail Server: the IP address of the server transferring your email.
Username: your username on the mail server.
Password: your password on the mail server.
Sender: To set the Event sender name, character length maximum is 48
without illegal and specific character. Default is blank. (With
blank then switch will send the email with device name.
Return-Path: To set the detail email detail address. For example:
xxx@xxx.xxx.xxx.xx. Character length maximum is 48
without illegal and specific character. Default is blank. (With
blank then switch will send the mail with username.
Email Address 1 – 6: email address that would like to receive the
alarm message.
To Next Page
Loading...
Need help?
General
