Rugged Ridge 13265.01 User Manual

P/N: 13265.01
Installation instructions 13265.04
2007-08 Jeep® Wrangler JK - Neoprene Rear Seat Covers
13265.09
2-Door Rear Seats
13265.53
Parts included: (1) Rear top cover
(1) Rear bottom cover
(2) Head Rest Covers
NOTE: Please read instructions before installing
Instructions:
Step(1)
Step (1)
Remove rear headrest from
seat. The headrest can be
removed by pressing the
two buttons located on the top
of the seat.
Step (2)
Slip upper seat cover over
rear seat. Note location
of headrest mounting holes.
Slip lower Velcro strip
between the upper and
lower portions of the seat
and secure. Connect zipper
and close.
Step (2)
Step (3)
Push seat cover over headrest
mounting plates. Secure under
plastic caps as shown.
Step (4)
Adjust upper seat cover as
needed for proper fitment.
Step (5)
Slip lower cover over seat
bottom and slide back clips
and straps through the gap
between the top section and
the lower seat section.
Fold and touble the seat so
that front to rear straps can
Step (3)
be secured.
Step (6)
With seat folded forward
loosen staps and attach front
strap to back clip. Repeat for all
three locations.

Rugged Ridge 13265.01 Specifications

General

Brand	Rugged Ridge
Model	13265.01
Category	Automobile Accessories
Language	English

Summary

Vehicle Seat Cover Installation

Remove Rear Headrests

Remove headrests by pressing the two buttons located on top of the seat.

Install Upper Seat Cover

Slip upper cover over seat, note headrest holes, secure Velcro strip, connect zipper.

Secure Headrest Mounting Plates

Push seat cover over headrest mounting plates and secure under plastic caps.

Adjust Upper Seat Cover Fitment

Adjust upper seat cover as needed for proper fitment.

Install Lower Seat Cover

Slip lower cover, slide clips/straps through gap, fold seat to secure straps.

Secure Seat Bottom Straps

With seat folded, loosen straps and attach front strap to back clip at three locations.

Tighten Seat Cover Straps

Pull straps attached to tighten, but do not over-tighten to avoid damage.

Secure Side Clips and Check Fit

Slide side clips between seat/fenderwell, fold back seat, check fitment.

Install Headrest Covers

Slide supplied headrest covers over headrests and secure with Velcro.

Reinstall Headrests

Insert headrest back onto the rear seat after cover installation.

Final Seat Cover Adjustment

Inspect and adjust seat cover fitment, folding seat as needed for final fit.