6
/
32
previous setting.
1.6.2.5 Output Status Setting
Switch to , press and turn the rotary control to select either ON or OFF. When
ON is selected, the device will Power on with the Output enabled. Selecting When OFF is
selected, the device will Power on with the Output disabled.
1.7 Function Description
1.7.1 Enable or Disable the Output
At any time you can press key to enable or disable the Output when the keypad is
unlocked.
1.7.2 Locking the Keypad to Avoid Accidental Operation.
At any time you can hold the rotary control for more than 2 seconds to lock the keypad,
there will be displayed on the right side of the interface; hold the rotary control again
for more than 2 seconds you can unlock the keypad, there will be displayed on the
right side of the interface.
1.7.3 10 Data Groups Preset（M0-M9）
The M0 Data Group is the default Data Group after power on. It should be noted that
any time an alternative Data Group is selected or any changes made to the existing settings
then M0 will be immediately overwritten with the newly selected data.
1.7.4 Shortcut keys to Select and Recall M1 or M2 Data Group
Hold key or key for over 2 seconds to shortcut recall the M1 or M2 Data
Group, and there will be Data Group Number displayed on the right side of the interface.
1.7.5 Select and Recall Any Specific Data Group.
Hold key for over 2 seconds, there will be Data Group Number displayed on the
right side of the interface. Turn the rotary control to select the required Data Group (M1 to
M9) , then press key to activate the selected Data Group.
To Next Page
Loading...
Need help?
General
