same way as used in the main interface. Press the SET key to return to the menu options and
press the SET key again to exit.
Set the Protection Values.
Press V/↑or A/↓to step up or down through the menu options to select S-OVP (Over-Voltage
Protection), S-OCP (Over-Current Protection) or S-OPP (Over-Power Protection) limits. Press the
rotary control to place the cursor at the required character of the numerical value you wish to
change. Set the value required in the same way as used in the main interface. Press the SET key
to return to the menu options and press the SET key again to exit.
When any of the protection value limits are reached the output will be automatically disabled.
These are the global system protection limits and should not be confused with preset Voltage and
Current.
Adjust the Screen Brightness
Press V/↑or A/↓to step up or down through the menu options to select B-LED, and then press
the rotary control to highlight the brightness setting value. Turn the rotary control to adjust the
brightness from 0 to 5 where 0 is the darkest and 5 is the brightest. Press the SET key to return to
the menu options and press the SET key again to exit.
Data settings for each Data Group
Selecting the Data Group to edit
Press V/↑or A/↓to step up or down through the menu options to select M-PRE, and then press
the rotary control. Turn the rotary control to select the number of the Data Group you wish to
view and edit. After completing the desired setting press and hold the SET key until the Data
Group number is shown on the right hand side of the screen. Pressing the set key again returns to
the Data Group menu options.
Selecting M-Pre ON / OFF
Press V/↑or A/↓to step up or down through the menu options to select M-PRE, and then press
the rotary control. Turn the rotary control to select the number of the Data Group you wish to
view and edit then press the rotary control again to allow modification of the M-PRE option. Turn
the rotary control to select either ON or OFF. When ON is selected it signifies that when the Data
Group is recalled the state of the unit main output will remain the same as it was prior to the
Data Group recall. When OFF is selected it signifies that when the Data Group is recalled the state
of the unit main output will be set to OFF regardless of previous setting. Press and hold the SET
key until the Data Group number is shown on the right hand side of the screen. The data value is
now saved to the indicated Data Group number. Pressing the set key again returns to the Data
Group menu options. To exit the Data Group menu press the set key again.
Adjust the selected DATA Group numerical values
To adjust any of the numerical values for the selected Data Group first use the V/↑or A/↓to step
up or down through the menu options to select the item to change. Then press the rotary control
and the numeric value will be highlighted by the cursor. Further presses of the rotary control will
cycle through the characters available. Turning the rotary control clockwise increases the value
To Next Page
Loading...
Need help?
General
